| SHEET LENGTHS - |
Measure from peak of ridge to end of rafter. |
| SHEETS NEEDED - |
Divide length of ridge by 3' for each side. Example: Ridge length divided by 3' = sheets needed per side of building. |
| RIDGE CAP QUANTITY - |
Divide length of ridge by 9 for number of pieces. Note: Ridge flashing should be lapped at next rib of panel. |
| EAVE TRIM - |
Total lineal feet of eaves divided by 10. |
| GABLE TRIM - |
Total lineal feet of gables divided by 10. |
| FASTENERS - |
(Husky Panel) To find number of panel fasteners, multiply total lineal feet of panel by 3. To find number of stitch screws required - one screw per lineal foot of panel. Note: Screws are available in bags of 250. |
| FASTENER SPACING - |
3" up from eave, 24" up the length of panels 1/2" from each rib. |
| SIDE LAP SEALANT/MASTIC - |
Total lineal feet of sheets and divide by 200' for number of rolls. |
| NEOPRENE CLOSURES - |
Bottom: inside - used at eave, under panels, 3' each. Top: outside - use at ridge, over panels and under ridge flashing, 3' each. 1 each per sheet of panel. |
Fastener Guideline
Screws need to be properly driven to ensure proper seal and holding strength. Sealing material slightly visible at edge of metal
washer. Assembly is weather tight.
Download installation booklets for our residential panels:
Husky/Norstar
EZSnap
|
